[Sidefx-houdini-list] 3d printing

Barrick, Simon simon at primalpictures.com
Wed Sep 26 10:29:03 EDT 2018


You also particularly need to watch out for non-manifold polys, 3d printers really don’t like those.
Polydoctor should attempt to fix those too, under the Topology tab…

Simon

From: Sidefx-houdini-list <sidefx-houdini-list-bounces at sidefx.com> On Behalf Of Antoine Durr
Sent: 26 September 2018 15:25
To: sidefx-houdini-list at sidefx.com
Subject: Re: [Sidefx-houdini-list] 3d printing

Closed hulls (e.g. polydoctor), size in mm, Z-up, primitives reversed, sized smaller than the build volume.

— Antoine


> On Sep 26, 2018, at 7:03 AM, herman02 at netvigator.com<mailto:herman02 at netvigator.com> wrote:
>
> hi all,
>
> I'm using the Houdini geometry for 3d printing, I use save geometry as .stl file, for some reason, the more high ended 3d printers can read the file while the cheaper version couldn't read it. Wonder is there any procedure in Houdini to clean up the file before exporting as object or 3d printing?
>
> thanks.
>
> kind regards
> Herman
>
> _______________________________________________
> Sidefx-houdini-list mailing list
> Sidefx-houdini-list at sidefx.com<mailto:Sidefx-houdini-list at sidefx.com>
> https://lists.sidefx.com:443/mailman/listinfo/sidefx-houdini-list<https://lists.sidefx.com:443/mailman/listinfo/sidefx-houdini-list>

_______________________________________________
Sidefx-houdini-list mailing list
Sidefx-houdini-list at sidefx.com<mailto:Sidefx-houdini-list at sidefx.com>
https://lists.sidefx.com:443/mailman/listinfo/sidefx-houdini-list<https://lists.sidefx.com:443/mailman/listinfo/sidefx-houdini-list>


More information about the Sidefx-houdini-list mailing list